CREATE COMPUTER NETWORKING USING WINDOWS XP
hello Networkers :D
Computer networks are connecting two or more computers, so that between one computer
with others to exchange resources such as file sharing, pri nter, etc. by using the protocol
Similarly, in this case TCP / IP. As computer networks have been widely used for various
needs, eg:
- MULTIPLAYER GAME
- OFFICE
- CAMPUS, ETC.
To create a network of computers required device as follows:
- Two or more computers
- LAN Card / NIC according to the number of computers (for now usually already onboard computer)
- UTP cable as needed
- Crimping Pliers
- RJ45 connector
- Switch / Hub if you want to use three or more computers
- Scissors
ok..
next..
After all the equipment we have collected a complete ready to make computer networks, following steps
are as follows:
DETERMINE HOW MUCH WILL MAKE WITH COMPUTER NETWORK?
This is necessary because the configuration of the network cable for two to three computers / more different.
To connect two computers is not necessary switches and using UTP cable with
wiring kind of straight, whereas for computer network with three or more using switches and
UTP cable with cross-over wiring configuration (Regarding the wiring will be discussed later).
INSTALLING THE CABLE RJ-45 UTP
Because in this tutorial we will use UTP cable as a medium, then we have to put up
RJ-45 connector on the cable to be plugged into the LAN CARD, as has been said before
two computer network configuration with three different computers, do the following:
Configuring two computers using a crossover
- Peel the outer skin utp cable ends using a crimping blade or scissors, with longapproximately 1.5cm.
- Then sort the colors with rules if one end of the cable using the T568A configuration the end of the cable using the T568.
- Once both ends of the color sorted according to the configuration above, averaged utp cable ends with cut a little part of the cable (the cable should not peeled)
- Insert the cable into the RJ -45 carefully, do not get them mixed up the order.
- Then crimping / cable clamp is menggu nDo terdengan crimping pliers until a clicking sound. (Remember in mengcrimping do not be too hard to press krn cause a broken connector.
INSTALLING UTP CABLE CONNECTOR WHICH IS ATTACHED TO PC
After utp cable connector installed, the next step is to plug the cable utp
LAN CARD computer, if only menggun will then attach the two computers that have installed UTP RJ -45
with cross-over configuration to each computer, but if it consists of three or more computers then
we have to use a switch / switch topology.
there are many in the market
switch / hub with a number of plug rj-45 as 4/8/16/32 port, about pemelihan stay adjusted
with needs. To install the UTP cable to the switch, you simply plug one RJ-45
which has been attached to the UTP cable was to one of the ports on the switch / hub and the other on the PC. If it is already
The plug will appear Connected LAN icon in the system tray computer:
thank you for reading arcticle CREATE COMPUTER NETWORKING USING WINDOWS XP
I will provide an explanation in the next article, namely,
configure ip address
Terimakasih anda telah membaca artikel tentang CREATE COMPUTER NETWORKING USING WINDOWS XP. Jika ingin menduplikasi artikel ini diharapkan anda untuk mencantumkan link https://computernetworkingworld.blogspot.com/2015/01/create-computer-networking-using.html. Terimakasih atas perhatiannya.